Pipe Hanger Straps

Use to support 1/2" copper tubing with included nails

Each strap comes with (2) 1" copper nails

Solid copper pipe strap

Fits copper tube sizes

Use this pipe strap to support 3/4" tubing with included nails

Each strap comes with (2) 1" copper nails

Solid copper pipe strap

Fits copper tube sizes

1" Insulating Suspension Clamp

Plastic insulating suspension clamp reduces noise from tubing expansion and contraction

Supports copper, PEX, polybutylene and ideally isolates CPVC tubing from wood

Impact resistant to 0 deg F

Sioux Chief's Metal Hanger Strap (524-10) is used to support CTS (PEX/Copper/CPVC), IPS or DWV pipe in both horizontal or vertical applications. Made from galvanized steel with alternating 1/4" and 3/16" pre-drilled holes. May be installed on floor joists or stud members, can be looped or wrapped around piping.

Sioux Chief metal hanger strap shall be used where necessary to support CTS, IPS or DWV pipe

Hanger strap shall be installed in accordance with national codes pertaining to hanger spacing and slope requirements

Metal hanger strap shall feature 1/4 or 3/16" pilot holes in an alternating pattern

Strap shall be no less than 3/4" wide

Sioux Chief 500, 501 and 502 series tube strap is used where necessary to fasten or secure CTS tubing and IPS piping in residential or commercial applications. Mount to wood, metal studs or joists using nail or screw in both holes. Refer to National or Local plumbing codes for proper hanger spacing requirements.

Sioux Chief 501 series tube strap shall be used where necessary to fasten or secure CTS tubing and IPS piping in residential or commercial applications

Mount to wood, metal studs or joists using nail or screw in both holes

Minimum recommended nail penetration is 3/4"

Copperized Steel Pipe Strap with Nails, Size: 1" CTS

Gauge is 22

Load is 24lbs